Hull Pro

Our 2-part clear, nano-formulation creates an ultra-smooth barrier on your hull. Its durable epoxy formulation creates a protective barrier between your hull and the water. The ultra-smooth finish of Hull Pro decreases vessel drag, meaning you can see an increase in speed, and a decrease in fuel consumption. It is not an antifouling paint, which means regular maintenance is still required. Contact us to determine if Hull Pro is suitable for you.

The surface should be completely dry and not have any trapped moisture. The application temperature of the air and the substrate should be between 41-95°F (5-35°C) and the temperature of the hull should be at least 5° higher than the dew point. You can check your dew point and surface temperature by using a handheld infrared thermometer. 

We recommend starting the application process in the morning to give the coating enough time to dry and cure before the sun goes down and temperatures begin to cool.

NOTE: If the above conditions are not met, Hull Pro will not lay out properly on the surface. If you’re unsure, please contact us prior to application. We’re here to help!

Please refer to this page for Hull Pro coverage.

With the proper care, Hull Pro can protect your vessel for up to 2 years without reapplication. If your vessel is knocking against the dock or you do see some scuffs or damage, you can touch up Hull Pro by sanding around the area and applying another coat of Hull Pro. Remember, you’ll have to wait 24 hours for your touch-up to dry, and 48 hours for Hull Pro to be fully cured after application (72 hours total) before you relaunch your vessel.

Hull Pro cures in 24 hours. We recommend waiting the full 24 hours prior to moving vessel (depending on temperature and humidity). Vessel immersion / launch time is 48 hours post-curing (72 hours post-application).

Absolutely. A good power washing can help remove stubborn and hard growth. We recommend using a 2500-3500 PSI gas power washer.

Everyone’s water type will differ. It’s important for you to check with your marina to understand growth rate and patterns for your water type. Hull Pro is a fouling-release formula and will require regular maintenance. We recommend you check our POST-APPLICATION CARE GUIDE for our recommended tools and tips for keeping Hull Pro looking its best on your hull, and for keeping your vessel protected. Maintenance with Hull Pro is as simple as a dive and scrub, a power-wash or a gentle cleaning with a silicone scraper and white 3M scouring pad.

To remove Hull Pro, you would need to fully sand it down to the bare substrate.